#2012 FORD ESCAPE GAS MILEAGE HOW TO#

This thread describes the DIY repair.Ĭorroded liftgate glass hinges: The hinges that hold the liftgate glass can also corrode in the Rust Belt. It's an easy and inexpensive repair: 0.5 hours of labor for one front link plus the part. The blower motor resistor is located on top of the HVAC duct behind the glove box and is easy to replace.įront sway bar links go bad often causing a knocking noise in the front end when driving slowly over small bumps. The part costs from $30 to $60 aftermarket parts are cheaper. Watch these videos.īlower motor resistor: If your A/C blower motor works only in 3-rd and 4-th speed, it's very likely that the blower motor resistor has failed. If a bad purge valve is confirmed, it's easy to replace. The EVAP system must be tested for leaks and the purge valve must be checked for not holding the pressure. Here is a good video explaining the repair.įailed Purge Valve: The code P0456 and/or P0455 could be caused by a bad purge valve/solenoid. Your mechanic may charge you about 2.2 hours of labor plus the part for the repair. The part is not too expensive, but takes some work to replace.

Worn ignition lock module: When one of the parts in the ignition lock module is worn out, it may cause a no-crank no-start condition or the vehicle may start after wiggling and pushing in the ignition key. Signs of automatic transmission problems.

#2012 FORD ESCAPE GAS MILEAGE HOW TO#

How to check the engine when buying a used car.How to get the best deal on a used car?.Buying a Used Car: 10 Common Mistakes to Avoid.

2012 ford escape gas mileage